Position: Index >

Low-battery-warning

2016-02-19 00:45  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.


A voltage divider consisting of Rl, R2, and R3 is used to set the input reference voltage below which the batteries are to be replaced. That reference voltage, at point A, is varied by Rl. With the voltage divider shown in Fig. 9-7, a range of 2 to 3.5 Vis possible. When the battery voltage drops below that at point A, the output ol IC1a, 1/. of a LM339 quad comparator, switches from high to low. That triggers IC1b, which is configured as an astable multivibrator. Feedback resistors R6 and R7, coupled with capacitor Cl, determine the time constant of the multivibrator.
Low-battery-warning

The output from IC1b is connected to LEDl through dropping resistor R8. With the circuit values as shown, the LED will flash at a rate of 3 Hz. Although this circuit was designed specifically to monitor RAM back-up batteries, it can of course be modified for use in just about any application where the condition of a battery must be found.



Reprinted Url Of This Article:
http://www.next.gr/power-supplies/chargers/low-battery-warning-l13166.html