Position: Index >

Two-Zone Intruder Alarm

2016-02-18 09:32  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.
Description:
This is a two-zone alarm - with automatic exit, entry and siren cut-off timers. It can be triggered by the usual types of normally-closed input devices - such as magnetic reed contacts - foil tape - PIRs etc. I've used a 12-volt supply in the diagram - but the circuit will work at anything from 9 to 15-volts. All you need do is select a siren, buzzer and relay to suit the voltage you want to use.

Two-Zone Alarm

Notes:
When you move Sw1 to the Set position - you have about 30 seconds to leave the building. If you re-enter through the Exit/Entry zone - the buzzer will sound - and you'll have about 30 seconds to switch the alarm off. The Instant zone has no entry delay. Anyone entering through the Instant zone - will sound the siren immediately.

About ten minutes after the normally-closed loops have been restored - the siren will switch off - and the alarm will return to standby mode. It can then be re-activated by a subsequent intruder. If you don't want the siren to sound a second time - add theOne-Time-Only Module. It forces the siren to switch off after the first ten minutes. And it prevents the alarm from activating a second time. This module has other uses - so it's worth a look.

Veroboard Layout:
Veroboard Layout

This alarm was developed for theBeginner's Guide To Cmos Timers. So the support material includes a particularly detailedCircuit Description. It also includes a parts list - a step-by-step guide to construction - a photograph of the prototype - and more.








Reprinted Url Of This Article:
http://www.zen22142.zen.co.uk/Circuits/Alarm/tza.htm