Position: Index >

rf alarm CIRCUIT (MC14093BC)

2016-02-19 21:49  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

This simple circuit is sure to have the police beating a
path to your door – however, it has the added advantage of
alerting you to their presence even before their footsteps fall
on the doormat.

radiowavealm rf alarm

The circuit transmits on Medium Wave (this is the small
problem with the police). IC1a, together with a sensor (try a
20cm x 20cm sheet of tin foil) oscillates at just over 1MHz. This
is modulated by an audio frequency (a continuous beep) produced
by IC1b. When a hand or a foot approaches the sensor, the
frequency of the transmitter (IC1a) drops appreciably.

Suppose now that the circuit transmits at 1MHz. Suppose also
that your radio is tuned to a frequency just below this. The 1MHz
transmission will therefore not be heard by the radio. But bring
a hand or a foot near to the sensor, and the transmitter`s
frequency will drop, and a beep will be heard from the radio.

Attach the antenna to a multiplug adapter that is plugged into
the mains, and you will find that the Medium Wave transmission
radiates from every wire in your house. Now place a suitably
tuned Medium Wave radio near some wires or a plug point in
your house, and an early-warning system is set up.

Instead of using the sheet of tin foil as the sensor, you
could use a doorknob, or burglar bars. Or you could use a
pushbutton and series resistor (wired in series with the 33K
resistor – the pushbutton would short it out) to decrease the
frequency of IC1a, so activating the system by means of a
pushbutton switch. In this case, the radio would be tuned to a
frequency just below that of the transmitter.

 

This article describes the rf alarm CIRCUIT (MC14093BC). The content is very simple, very helpful. Components in this article can help you understand better understanding of this article. For example, in this article, you can go to find and buy these components:MC14093BC.

 


Reprinted Url Of This Article:
http://wiringdiagramcircuit.com/rf-alarm-2/