Position: Index > Amplifier Circuit >

Class AB amplifier 12V

2016-05-05 07:27  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.
Class AB Audio Power Amplifier.

Class AB amplifier is an amplifier configuration that stands somewhere between Class A and Class B configurations. A small diode biasing voltage keeps the output transistors ON even if there is no input signal. The transistors will operate normally in their active region for any small input signal.In simple words, one transistor will be ON for more than one half cycle of the input signal.  This avoids crossover distortion. Anyway, a small amount of collector current will flow in the idle condition, but it is negligible when compared to the Class A configuration. . A simple, high quality audio power amplifier that can be operated from 12V dc is shown below. Such an amplifier is very suitable for car audio applications. The circuit is very straightforward and uses commonly available components. Power output of this amplifier is around 10W.


The circuit is purely based on transistors. The first stage of the circuit is the long tailed pair (LTP) built around the transistors Q1 and Q2. Transistors Q10, Q11 and associated components form a constant current source for the long tailed pair. Resistors R15 and R3 are biasing resistors. The second stage of the circuit is built around transistor Q3. Transistors Q9 and Q6 form a constant current source for the second stage. Resistor R8 is the feedback resistor and it plays a vital role in reducing distortion. The final power amplification stage of the circuit is based on the complimentary pairs Q8 and Q5. Q7 and Q4 are the driver transistors for Q8 and Q5 respectively. Audio output is coupled to the loud speaker through capacitor C3. D1 and D2 are biasing diodes. C4 is the power supply filter capacitor. This amplifier circuit can be operated from anything between 12 to 16 volts.

Circuit diagram. class ab amplifier

Class AB amplifier

Notes. Use 12V DC for powering the amplifier. An optional 10K POT can be added in series to the input for volume control. Use a 4 ohm/20W speaker as the load. Transistors Q8 and Q5 must be fitted to a proper sink.