Position: Index > Amplifier Circuit >

DIY 4x22W car audio amplifier based on TDA7384

2015-01-02 05:17  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

So this time I decided to make pretty simple but powerful enough audio amplifier. For this I’ve chosen quad bridge car audio amplifier TDA7384 which has four input and four output channels with power capability 4x35W(4??).

TDA7384_PCB.JPG

 

If connect to car battery where operating voltage is about 13.2V, then each channel can give 22W(4??) a€“ what is more than enough for me. This amplifier I probably will use to test audio processor TDA7313 which is stil in development phase. I didn’t find much information about this chip on the internet so I decided to built it and try on my own.

As datasheets of TDA7384 says it is low distortion, low output noise, low external component count. Also has Stand-By function and Mute function. It has several protections like from output short circuit to GND or to Vs, capable to handle very inductive loads, thermal limiter, load dump voltage. TDA7384 is an AB power amplifier cased in flexiwatt25 (eagle library is included in project archive) package wich is designed for high end car radio applications. It allows rail to rail output voltage swing with no need of boot-strap capacitors.

tda7384sch.PNG

(click to enlarge)

 

I have followed the schematic in datasheed when building circuit. In datasheet you may also find PCB layout but it is two layered and didn’t fit to may box I’ve chosen. So I have made single sided PCB 50X100mm.

tda7384pcb.PNG

 

As I put pins on PCB for ST-BY and Mute but I not using them, I connected these pins to VCC like it is shown in PCB view. According to datasheet St-By and Mute turns off amplifier if signal in input is lower than 3.5V. So it is recommended to connect these pins to Vcc if not used.

Maximum power dissipation of chip is 80W(Tcase=70?oC), so it can handle 4 channels working at power of 20W each. But of course chip in a box doesn’t have good ventilation so I’ve put a radiator to ensure that amplifier effectively dissipates heats. I didn’t try to load amplifier to maximum to se if it doesn’t heat up to much. But at normal sound level it stays warm what is normal.

TDA7384_box.JPG

 

Dont forget to put thermal paste between chip and radiator to ensure lower thermal resistance. And here we go a€“ brand new power amplifier ready to go:

TDA7384_coated.JPG

 

When I will try it more I will write comments on it.

Project files are here: TDA7384 Eagle Files.

Thoughts Aside

When you get a car audio amplifier, you could get great cell phone deals. Almost all cell phones can be charged with a car charger. The way digital cameras need to be charged or their battery needs to be replaced. With all the hassle, wireless technology like wireless speakers, wireless keyboards and mouse are much more user-friendly.


Reprinted Url Of This Article:
http://www.scienceprog.com/diy-4x22w-car-audio-amplifier-based-on-tda7384/