Position: Index > Amplifier Circuit >

High-Side Current Sense Amplifier Coverts 4-20mA Signal to 0

2015-01-05 20:39  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.
This is a simple circuit that can be used to convert a 4-20mA signal to a 0V to 5V analog voltage. It is ideal conversion to digital with an analog-to-digital converter (ADC). In this circuit, a current-sense amplifier (IC1) is used to monitor the loop current. To generate a ground-referenced output that ranges from 0V at 4mA to 5V at the full-scale loop current (20mA), a reference/op-amp/comparator device (IC2) is employed. Here is the circuit :

High Side Current Sense Amplifier Coverts 4 20mA Signal to 0 5V2 circuit schematic

Using the resistor values shown (R2-R6), the output of IC at pin 8 is approximately 6.25V at 20mA and 1.25V at 4mA. An output range of 0.05V to 5.045V is generated by IC2 that is configured as unity-gain difference amplifier. Beside that, IC2 comparator? can be used to flag a pre-set loop current or? monitor input voltage.

Using 1% resistors, this circuit will perform well. The worst-case output error is 5% based on Monte Carlo analysis. However, the performance with unmatched components was better than 1% at full-scale. The accuracy of this circuit is better than 1% across the operating range, that can be done? by compensating for the dominant error. [Source: maxim-ic.com]




Reprinted Url Of This Article:
http://freecircuitdiagram.com/2010/02/26/high-side-current-sense-amplifier-coverts-4-20ma-signal-to-0-5v/