Position: Index > Amplifier Circuit >

Pwm servo amplifier

2015-01-04 05:46  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

PWM is  a technique to reduce power dissipation in the amplifier to a minimum. A major feature of the PWM servo amplifier is elimination of a pulse transformer. A 150 kHz pulsewidth modulated signal is applied to U3, with its complementary outputs applied to identical circuits to drive the load. The PWM frequency is determined by the motion controller, but should be between 25 and 100 Khz..When point A increases, Q2 is on and point B is at ground potential. The Vee for Ul is maintained through Dl, and Ql is held off by D2. When point A decreases, Q2 turns off, point Cis pulled low by C2, which turns Ql on. The time constant for Rl, R3, and C2 can hold Ql on just long enough to allow the voltage at point B to start rising.

Pwm-servo-amplifier 
 

As point B rises, it charges C2 by forward biasing D3, maintaining point C low with respect to Ul, and keeping Ql turned on. With point B at 40V, D2 is off and point C is held low by Rl and R2, and Vee for Ul is maintained by the charge on Cl. When point A increases again, Q2 again turns on, C2 pushes point C high, and turns Ql off long enough to allow the voltage at point B to start falling. C2 is now discharged by reverse-biased D3, which keeps point C high with respect to Ul, and keeps Ql off. Once point Breaches ground potential, Dl again turns on, recharging Cl, and maintaining Vee to Ul. D2 also turns on and keeps Ql off.