Position: Index > Amplifier Circuit >

Signal Conditioning Amplifier for Piezofilm Sensor (MAX4257)

2015-01-02 22:00  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

The signal can be converted by piezoelectric films in many ways such as thermal to electrical (temperature sensor), mechanical to electrical (microphone), and electrical to mechanical ( a loudspeaker). The circuit is signal conditioning amplifier for piezofilm sensor which use three op amps and has a high-input-impedance differential charge. Here is the circuit :

Signal Conditioning Amplifier for Piezofilm Sensor circuit schematic

This circuit use a voltage? source? with a capacitor in series as the electrical analog? of a piezofilm sensor. The differential charge amplifier is endowed by a dual op amp (IC1)? with low supply current and single-supply operation . The input common-mode? voltage? is set by a small bypass capacitor (C3), R2, R1 at the mid-supply level. The C1 and C2 are used to set AC gain for the differential stage. A gain of C1/CEQ is 96.

The differential amplifier also is used to act as a first-order high-pass filter. The resistors R9, R8, R6, and R5 with IC2 perform differential-to-single-ended conversion. Using the values shown, the different gain is 20.

This article describes the Signal Conditioning Amplifier for Piezofilm Sensor (MAX4257). The principle is very simple, very practical. The circuit components can help you understand better grasp this principle. For example, in this circuit, you can go to find and buy these components:MAX4257.


Reprinted Url Of This Article: