Position: Index > Audio Circuit >

TEA2025B amplifier circuit

2014-11-02 19:46  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

A very simple audio amplifier electronic project that can be used in small portable audio applications can be designed using the TEA2025 audio amplifier IC . This audio power amplifier project supports a wide input voltage range between 3 and 15 volts .

TDA7241 20 watt car audio amplifier schematic circuit project Wireless audio receiver circuit diagram Electronic tuning fork circuit diagram project 5 bands Stereo graphic Equalizer circuit diagram

Input capacitor is PNP type allowing source to be referenced to ground.
In this way no input coupling capacitor is required. However, a series capacitor (0.22uF)to the input side can be useful in case of noise due to variable resistor contact.

The bootstrap connection allows to increase the output swing. The suggested value for the bootstrap capacitors (100μF) avoids a reduction of the output signal also at low frequencies and low supply voltages.

The voltage gain is determined by on-chip resistors R1 and R2 together with the external RfC1 series connected between pin 6 (11) and ground. The frequency response is given approximated Input capacitor is PNP type allowing source to be referenced to ground.
The frequency response is given approximated : VOUT/VIN= R1/(Rf +R2 +(1/JWC1))
The maximum output power that can be obtained using the TEA2025 audio amplifier in stereo mode is around 2.3 watts on a 4 ohms load .
TEA2025 amplifier circuit diagram