# Band Pass Filters

### Band Pass Filter

A band-pass filter is a circuit which is designed to pass signals only in a certain band of frequencies while attenuating all signals outside this band. The parameters of importance in a bandpass filter are the high and low cut-off frequencies (fHand fl*),*the bandwidth (BW), the centre frequency fc,centre-frequency gain, and the selectivity or Q.

There are basically two types of bandpass filters viz wide bandpass and narrow bandpass filters. Unfortunately, there is no set dividing line between the two. However, a bandpass filter is defined as a wide bandpass if its figure of merit or quality factor Q is less than 10 while the bandpassfilters with Q > 10 are called the narrow bandpass filters.Thus Q is a measure of selectivity, meaning the higher the value of Q the more selective is the filter, or the narrower is the bandwidth (BW). The relationship between Q, 3-db bandwidth, and the centre frequency fcis given by an equation

For a wide bandpass filter the centre frequency can be defined as?where fHand fLare respectively the high and low cut-off frequencies in Hz.In a narrow bandpass filter, the output voltage peaks at the centre frequency fc*.*

### Wide Bandpass Filter

A wide bandpass filter can be formed by simply cascading high-pass and low-pass sections and is generally the choice for simplicity of design and performance though such a circuit can be realized by a number of possible circuits. To form a ± 20 db/ decade bandpass filter, a first-order high-pass and a first-order low-pass sections are cascaded; for a ± 40 db/decade bandpass filter, second-order high-? pass filter and a second-order low-pass filter are connected in series, and so on. It means that, the order of the bandpass filter is governed by the order of the high-pass and low-pass filters it consists of.

A ± 20 db/decade wide bandpass filter composed of a first-order high-pass filter and a first-order low-pass filter, is illustrated in fig. (a). Its frequency response is illustrated in fig.*(b).*

### Narrow Bandpass Filter.

A narrow bandpass filter employing multiple feedback is depicted in figure. This filter employs only one op-amp, as shown in the figure. In comparison to all the filters discussed so far, this filter has some unique features that are given below.

1. It has two feedback paths, and this is the reason that it is called a multiple-feedback?filter.

2. The op-amp is used in the inverting mode.

The frequency response of a narrow bandpass filter is shown in fig(b).

Generally, the narrow bandpass filter is designed for specific values of centre frequency fcand Q or fcand BW. The circuit components are determined from the following relation-ships. For simplification of design calculations each ofC1and C2may be taken equal to C.

R1= Q/2∏ fcCAf

R2=Q/2∏ fcC(2Q2-Af)

and R3= Q / ∏ fcC

where Af, is the gain at centre frequency and is given as

Af= R3/ 2R1

The gain Afhowever must satisfy the condition Af< 2 Q2.

The centre frequency fcof the multiple feedback filter can be changed to a new frequency fc‘ without changing, the gain or bandwidth. This is achieved simply by changing R2to R’2so that

R’2= R2[fc/f’c]2

Reprinted Url Of This Article:

http://www.circuitstoday.com/band-pass-filters

- An analog to digital converter principle explanation
- The summary of a remote digital thermometer circuit diagram
- LTC1407 Analog to Digital Converter Pin Configuration and Da
- Digital Multiple-Gang Potentiometer Control Circuit
- Single 2.7V Supply 4MHz 4th Order Lowpass Butterworth Filter
- Digital Step-Km Counter Circuit Schematic
- Dual Direction Digital Ping-Pong by 555 Timer
- Series Inductor Filter
- Temperature Probe for Digital Multi Meter
- Four-Output Filter Circuit
- Digital Bike Tachometer(CD4026)
- 60 HZ not pass filter using IC 741
- Digital-tach-dwell-meter
- Turntable Rumble Filter
- Active high pass filter circuit using LM741
- 4-Bit Analog to Digital Converter(TLC3074 )
- Digital Radar Speedometer
- Digital Delay Unit For Surround Sound, Reverb Echo (PT2399)
- Digital Voltmeter with 3-Digit Output by PIC16F676
- How to build Pulse Width Modulation DC Motor Control
- Pulse Width Modulation DC Motor Control
- Tunable notch filter to suppress hum
- Digital tv antenna
- Band Pass Filters
- Audio noise filter circuits (2N3819)