# Full Wave Rectifier Circuit with Averaging Filter

This circuit is average reading use rms calibrated AC voltmeter. Deletion of C2 removes the averaging function and provides a precision full-wave rectifier, and deletion of C1 provides an absolute value generator. Circuit operation may be understood by following the signal path for negative and then for positive inputs. For negative signals, the output of amplifier A1 is clamped to 0.7V by D1 and disconnected from the summing point of A2 by D2. A2 then functions as a simple unity-gain inverter with input resistor, R1, and feedback resistor, R2, giving a positive going output. For positive inputs, A1 operates as a normal amplifier connected to the A2 summing point through resistor, R5. Amplifier A1 then acts as a simple unity-gain inverter with input resistor, R3, and feedback resistor, R5. A1 gain accuracy is not affected by D2 since it is inside the feedback loop. Positive current enters the A2 summing point through resistor, R1, and negative current is drawn from the A2 summing point through resistor, R5. Since the voltages across R1 and R5 are equal and opposite, and R5 is one-half the value of R1, the net input current at the A2 summing point is equal to and opposite from the current through R1 and amplifier A2 operates as a summing inverter with unity gain, again giving a positive output. Here is a schematic drawing :

The circuit becomes an averaging filter when C2 is connected across R2. Operation of A2 then is similar to the Simple Low Pass Filter previously described. The time constant R2C2 should be chosen to be much larger than the maximum period of the input voltage which is to be averaged. Capacitor C1 may be deleted if the circuit is to be used as an absolute value generator. When this is done, the circuit output will be the positive absolute value of the input voltage. The amplifiers chosen must be compensated for unity-gain operation and R6 and R7 must be chosen to minimize output errors due to input offset current.

*Source Circuit : National Semiconductor Application*

Reprinted Url Of This Article:

http://circuitdiagram-schematic.com/745/full-wave-rectifier-circuit-with-averaging-filter/

- 4.5Mhz notch filter
- Tone probe for testing digital ics
- Band Stop Filter
- FSK Filter circuit
- Square Root Mode for AD532 Analog Processor
- speech filter
- Digital Levels Scope Displays 2 Logic Signals On 1 Scope
- Differential Analog Switch
- Low-Capacitance High-Impedance Video Buffer (2N5139)
- Arduino and DS18B20 – 1-wire digital thermometer
- Low frequency Butterworth and optimal Wiener ECG filters
- Adapter for Experimenter, Dual for Digital and Analog Suppl
- Oil - digital DC voltage gauge
- On-off control SCR with logic gate IC
- Making a Digital Compass
- Digital Isolation and Termination (TSSOP20)
- Filter Circuits
- Low-pass active filter (UA741)
- Digital Signal Processing ??? Applications
- Digital-frequency-detector
- A digital counter circuit
- Five-pole active filter
- Low-Capacitance High-Impedance Video Buffer
- Programmable Photovoltaic Transimpedance Circuit (AD822)
- Handling the Digital Input Output in AVR Micro Controllers