﻿ How to build 2nd Order Opamp Filters_Circuit Diagram World ﻿
Position: Index > Basic Circuit >

# How to build 2nd Order Opamp Filters

2015-01-11 22:19
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

## Description

The figures below illustrate using opamps as active 2nd order filters. Three 2nd order filters are shown, low pass, high pass, and bandpass. Each of these filters will attenuate frequencies outside their passband at a rate of 12dB per octave or 1/4 the voltage amplitude for each octave of frequency increase or decrease outside the passband.

First order low or high pass cutoff frequency (-3dB point) = 1/(2pi*R*C)2nd order low or high pass cutoff frequency (-3dB point) = 1/2pi(R1*R2*C1*C2)^.5Example for 200 Hz cutoff frequency - R1=R2=7.95K, C1=C2=0.1uF

## Circuit diagram

Reprinted Url Of This Article:
http://www.circuit-finder.com/categories/audio/audio-filter/582/2nd-order-opamp-filters
Maybe you like
﻿