Position: Index > Basic Circuit >

Notch Filter: The Circuit’s Diagram and The Design Formula

2015-01-09 19:09  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

Notch filter is known as band-cut filter or band-reject filter. The fuction of this filter is to remove some frequency portion of a signal. The schematic diagram of this filter circuit, a second order notch filter is depicted in the figure below.

 

op amp notch filter circuit schematic

The formula is actually complicated, but by taking the R3=R4 and C1=C2, the filter’s frequency response? formula become very simple, as shown in the figure above. By selecting C1, C2 = 47 nF, R1, R2 = 10 k, R3, R4 = 68 k, you’ll get a frequency respon of 50Hz notch, similar to hum filter in our previous circuit ( hum filter? using op-amps and hum filter using transistor).



Reprinted Url Of This Article:
http://freecircuitdiagram.com/2008/11/27/notch-filter-the-circuits-diagram-and-the-design-formula/