Position: Index > Battery Circuit >

12 Volts Lead Acid Battery Charger

2016-05-12 07:31  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

12 Volts lead acid battery charger


12 Volts Lead Acid Battery Charger Circuit

Except for use as a normal Batter Charger, this circuit is perfect to ‘constant-charge’ a 12-Volt Lead-Acid Battery, like the one in your flight box, and keep it in optimum charged condition. This circuit is not recommended for GEL-TYPE batteries since it draws to much current.

12 volts lead acid battery charger circuit

PARTS LIST
R1120Ω
R282Ω
R310KΩ
R433KΩ
R522KΩ
P12.2KΩ
C110μF 63V
C210μF 63V
D1IN5401
D2LED
Q1BD140
Q2BC547
IC1LM350K OR LM350T

The above circuit is a precision voltage source, and contains a temperature sensor with a negative temperature co?ficient. Meaning, whenever the surrounding or battery temperature increases the voltage will automatically decrease. Temperature co?ficient for this circuit is -8mV per °Celcius. A normal transistor (Q1) is used as a temperature sensor.
This Battery Charger is centered around the LM350 integrated, 3-amp, adjustable stabilizer IC. Output voltage can be adjusted with P1 between 13.5 and 14.5 volt. T2 was added to prevent battery discharge via R1 if no power present. P1 can adjust the output voltage between 13.5 and 14.5 volts. R4’s value can be adjusted to accommodate a bit larger or smaller window. D1 is a large power-diode, 100V PRV @ 3 amp. Bigger is best but I don’t recommend going smaller.

lm350k Regulator IC

LM 350 Regulator IC

The LM350’s ‘adjust’ pin will try to keep the voltage drop between its pin and the output pin at a constant value of 1.25V. So there is a constant current flow through R1. Q1 act here as a temperature sensor with the help of components P1/R3/R4 who more or less control the base of Q1. Since the emitter/base connection of Q1, just like any other semiconductor, contains a temperature co?ficient of -2mV/°C, the output voltage will also show a negative temperature co?ficient. That one is only a factor of 4 larger, because of the variation of the emitter/basis of Q1 multiplied by the division factor of P1/R3/R4. Which results in approximately -8mV/°C. To prevent that sensor Q1 is warmed up by its own current draw, I recommend adding a cooling rib of sorts.
(If you wish to compensate for the battery-temperature itself, then Q1 should be mounted as close on the battery as possible)
The red led (D2) indicates the presence of input power.

lm350k, lm350t  pinout connection diagrams

Depending on what type of transistor you use for Q1, the pads on the circuit board may not fit exactly (in case of the BD140).
Caution: Adjust the voltage of capacitor C1 according to the input voltage. Example, if your input voltage will be 24 volt, your C1 should be able to carry at least 50V.

Please send your ideas, which are very important for our success…

Share
Reprinted Url Of This Article:
http://www.electronicecircuits.com/electronic-circuits/12-volts-lead-acid-battery-charger