Position: Index > Bridge Circuit >

# 100_Hz_WIEN_BRIDGE

2016-05-14 13:17

Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

Simple RC-tuned oscillator uses only two resistors (R1 and R2) and two capacitors (C1 and C2) to set frequency.Feedback path covers both FET stages. Set R6 for best sine-wave output. For other audio frequencies, change value of R in ohms and C in farads in equation f = 1 /6.28RC where frequency is in hertz, R = R1 = R2, and C = C1 = C2.-R. P. Turner, FET Circuits, Howard W. Sams, Indianapolis, lN, 1977, 2nd Ed., p 48-50.

Maybe you like

Similar Circuit Diagram

- Wien-bridge-oscillator
- Low Frequency Wien Bridge Oscillator
- PROGRAMMABLE_BANDPASS_USING_TWIN_T_BRIDGE
- BRIDGE_AMPLIFIER
- Bridge Rectifier Demonstrator Circuit Diagram
- Wien bridge sine wave oscillator circuit composed of LM101A
- QRP_SWR_BRIDGE
- Stabilized-wien-bridge-oscillator
- The sensor bridge drive amplifier circuit
- Wien bridge oscillator with FET (UA741)
- The drive circuit of bridge sensor
- Three-phase bridge type thyristor rectifier circuit
- The bridge driving circuit composed of the OPA502
- XTR101 bridge input、current excitation circuit
- STABILIZED_WIEN_BRIDGE_OSCILLATOR
- DMAl0 Double half bridge translation circuit principle diagr
- Half-bridge power conversion circuit
- BRIDGE_TRIGGERED__TRIAC
- Wien-Bridge Oscillator Using Incandescent lamp Stabilizer
- 50_kHz_MEACHAM_BRIDGE
- MSK4205 H-Bridge PWM Motor Driver Equivalent Circuit Schemat
- SINGLE_SUPPLY_WIEN_BRIDGE_OSCILLATOR
- RLC_BRIDGE
- VARIABLE_WIEN_BRIDGE_OSCILLATOR
- Bridge-Tee RF Diplexer