Position: Index > Bridge Circuit >
  • 5W / 8 Ohms Bridge Amplifier based on Two LM380s

    2016-05-14 22:55:2163

    The Audio amplifier described here uses two small amplifiers like LM380 mounted in bridge. Two smallamplifiersLM380(2.5Wmaxineach18V), which mountedbri...

  • AC_BRIDGE

    2016-05-14 22:42:4260

    The circuit provides a simple and cost-effective solution to matching resistors and capacitors. Impedances ZR and Zx form a half-bridge, while OSC and ...

  • Wien Bridge Sine-Wave Generator Circuit Composed of F007

    2016-05-14 22:26:1064

    As seen in the figure is wien bridge sine-wave generating circuit. This circuit uses voltage stabilizing diode to stablize amplitude, and the oscillate...

  • Precise Bridge Isolation Amplifier Circuit

    2016-05-14 22:22:2160

    Precise bridge isolation amplifier circuit is shown in the chart below.0 ~10mV unipolarity signal outputed by bridge would be enlarged by 100 times by ...

  • 325_KC_BRIDGED_T_FILTER

    2016-05-14 22:12:0361

    Used in magnetometer having large amounts of odd harmonics and only feeble second harmonk at secondary of sensing probe. Permits ampli-flying only seco...

  • AIR_FLOW_SENSING_THERMISTOR_BRIDGE

    2016-05-14 22:02:1561

    Using the thermistor-bridge circuit, you can detect system-cooling air losses caused by filter or inlet blockage or fan failure. One thermistor is moun...

  • BRIDGE_GATE_TEST_CIRCUIT

    2016-05-14 22:00:0460

    Two-state a-c bridge having biased tunnel-diode in one arm can be used as gale when balanced in one of its stable states.-F. W. Kantor, Tunnel-Diode Ga...

  • BRIDGE_BALANCE_INDICATOR

    2016-05-14 21:39:0865

    Indicator provides an accurate comparison of two voltages by indicating their degree of balance (or imbalance). Detecting small variations near the nul...

  • MC33886 IC H-Bridge Pinout Description and Datasheet

    2016-05-14 21:38:1474

    Thepinout schematic of MC33886 H-Bridge ICis illustrates in the following picture. According to the datasheet, the MC33886 IC incorporates internal con...

  • High_resolution_continuous_output_sampled_bridge

    2016-05-14 20:58:0861

    Figure 4-18 shows a sampled bridge with continuous output and high resolution.Figure 4-19 shows the waveforms. Traces A, B, C, and D show the A1A outpu...

  • DC Motor-Driver H-Bridge Circuit (BUZ11)

    2016-05-14 20:52:17120

    This article describes the DC Motor-Driver H-Bridge Circuit (BUZ11). The principle is very simple, very practical. The circuit components can help you ...

  • Three-phase bridge type thyristor rectifier circuit

    2016-05-14 20:11:0263

    The three-phase bridge type thyristor rectifier circuit is as shown in the figure. The difference between this circuit and the three-phase bridge type ...

  • Diode_bridge_based_rectifier_AC_voltmeter

    2016-05-14 19:09:5062

    Figure 4-41 shows a circuit that provides both ac and dc outputs for inputs up to 2.5 MHz, Figure 4-42 shows the waveforms. Trace A shows the input sin...

  • RLC_BRIDGE

    2016-05-14 18:40:3672

    Maxwell bridge uses only one re-active element for measuring resistance, inductance, and capacitance. Wagner ground balances stray internal capacitance...

  • Bridge rectifier symbol

    2016-05-14 18:09:4460

    Bridge rectifier symbol The schematic diagram come from circuit: Rectifier circuit power supply. Go to that page to read the explanation about above po...

  • Phase-shifting Control Circuit of 1000W Full Bridge Soft Sw

    2016-05-14 17:50:0772

    1000W full bridge soft switching power supply IC control system of application 100kHz,1000W phase-shifting control and its circuit is showed as the pic...

  • Phase-shifting Control Circuit of 1000W Full Bridge Soft Sw

    2016-05-14 17:32:5468

    1000W full bridge soft switching power supply IC control system of application 100kHz,1000W phase-shifting control and its circuit is showed as the pic...

  • XTR101 ELectrlcal Bridge InPut, Voltage Excitation Circuit

    2016-05-14 16:55:4160

    As shown, this circuit uses the voltage regulator tube LM129 to generate a 6.9V voltage reference, andthe 6.9V voltage reference provides 1.0147mA curr...

  • BRIDGE_WITH_AGC_ON_BOTH_DIODES

    2016-05-14 16:14:1062

    Agc is applied to center tap of transformer, to turn one diode off while other is being turned on. Attenuation can be 40 db over bandwidth up to 250 Mc...

  • 16W Bridge Amplifier using LM383

    2016-05-14 16:09:3061

    The following diagram is 16W audio amplifier circuit. The circuit built based 2 pieces of power IC LM383 in bridge connection, so this amplifier is an ...

  • Time_domain_bridge

    2016-05-14 15:54:5762

    Figure 4-22 shows a bridge circuit that operates in the time domain, and is particularly suitable for capacitance measurement. With S1 closed, the comp...

  • The applications of the full-bridge driver UBA2030T

    2016-05-14 15:53:2363

    The PHILIPS company uses the BCD750 power logic process method to produce the UBA2030T, this device is designed as one kind of high-voltage IC that can...

  • bridge photoelectric detector composed of photosensitive res

    2016-05-14 14:37:2861

    In the industrial optical measuring devices, the photosensitive resistor can be used to form the bridge photoelectric detector, just as shown in the fi...

  • CP2102 USB-to-Serial Bridge Driver Installation

    2016-05-14 14:10:5665

    1. Overview We use the Silicon Labs CP2102 USB-to-UART Bridge Controller in several of our products to provide USB connectivity while communicating via...

  • Power_op_amp_bridge_amplifier_with_differential_output

    2016-05-14 13:17:5660

    The differential output of the LM12 (Fig. 10-46) amplifier almost doubles the voltage swing delivered to the load. The diodes clamp the outputs to the ...

  • 100_Hz_WIEN_BRIDGE

    2016-05-14 13:17:1860

    Simple RC-tuned oscillator uses only two resistors (R1 and R2) and two capacitors (C1 and C2) to set frequency.Feedback path covers both FET stages. Se...

  • 50_Hz_WIEN_BRIDGE_NOTCH_FILTER

    2016-05-14 13:14:5363

    Uses opamp in circuit having essentially zero output impedance, making additional buffer amplifier unnecessary. Article gives design theory and covers ...

  • Full-Bridge converter electrical schematic diagram

    2016-05-14 13:11:3961

    Full-Bridge converter typical waveform:...

  • THERMISTOR_BRIDGE

    2016-05-14 12:42:1162

    Bridge is formed by thermistor with R1, R4, R5, and R6. Unbalance is sensed by CA3046 IC having two matched pairs of transistors, with additional outpu...

  • Single-Chip USB to UART Bridge-Details in CP2102EK

    2016-05-14 12:28:16153

    The CP2102 is a highly-integrated USB-to-UART Bridge Controller providing a simple solution for updating RS-232 designs to USB using a minimum of compo...

Maybe you like