Position: Index > Bridge Circuit >
  • Wien Bridge Sine Wave Oscillator Circuit

    2016-05-14 12:11:1862

    As seen in the figure, the oscillator frequency is around 1kHz, and the circuit uses stabilivolt 2DW78 to stablise the voltage. If we replace the coaxi...

  • WIEN_BRIDGE_FILTER

    2016-05-14 11:50:0062

    Most audio tone controls affect midband gain, and they often create booming or hissing sounds when activated. You can avoid these problems by using a d...

  • NOISE_BRIDGE

    2016-05-14 11:47:2360

    Used with communication receiver to measure impedance at antenna terminals or at end of transmission line, as required for adjusting antenna matching a...

  • Three-phase full-bridge application circuit diagram

    2016-05-14 10:28:4260

    Pulse transformer can be tank-shaped Mn-Zn ferrite. Generally used U30 core or SEAR2: l pulse transformer. Three-phase full-bridge circuit diagram show...

  • Strobed Supply Improves Strain Gauge Bridge Efficiency

    2016-05-14 10:25:4962

    The following schematic diagram shows a method to reduce power consumption without sacrificing the bridge signal output level of a strain gauge. Many s...

  • Bridge Rectifier Demonstrator Circuit Diagram

    2016-05-14 10:14:5261

    Bridge rectifier demonstrator circuit is a AC/DC conversion circuit. Bridge rectifier demonstrator circuit shown as in the picture reveals how the two ...

  • Low Distortion Wien Bridge Oscillator

    2016-05-14 10:09:3166

    This Wien bridge oscillator uses incandescent lamp to stabilize its amplitude. This amplitude stabilization gives a low distortion output.? Multiple fr...

Maybe you like