Position: Index >

Car subwoofer filter

2017-01-16 18:22  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

Description.
Here is the circuit diagram of a simple subwoofer filter that can be operated from a 12V DC supply. Such a circuit is very useful in automobile subwoofer applications. The circuit is nothing but a low pass filter whose pass frequency can be adjusted between 60 to 160 Hz.
The circuit is designed around the TL072 dual BIFET opamp IC. Out of the two opamps inside the chip, IC1A is wired as a buffer. The left and right audio inputs after mixing is fed to the input of the IC1A using the DPDT switch S1. Switch S1 is the phase control switch which can be used to make the subwoofer in phase with other speakers. When S1 is in position 2, 180 degree phase shift will be induced.POT R7 can be used for controlling the level. IC1B forms the low pass filter whose pass frequency can be controlled by adjusting the dual gang POT R13.

Circuit diagram .

car subwoofer filter circuit

Notes.

Assemble the circuit on a good quality PCB. The circuit can be powered from 12V DC. IC1 must be mounted on a holder. S1 is a DPDT switch. R13 should be a dual gang linear POT. C5 and C6 must be polyester capacitors. POT R13 can be used for adjusting the pass frequency. POT R7 can be used for adjusting the level.