Position: Index > Control Circuit >

Playstation Dual Force 2 controller connector pinout

2015-03-02 02:39  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

Dual force 2 Controller

1DATABrown wire = Pin 1 on control board
2CMDOrange wire = Pin 2 on control board
39VDCWhite wire = Pin 4 on control board
4GNDPurple Black wire: Purple = Pin 8 on control board. Black = pin 3 on control board
5VCCRed Wire = pin 5 on control board
6ATTYellow wire = pin 6 on control board
7CLKBlue wire = pin 7 on control board
8N/CNot connected (not used in PSX or PS2 controls and often not present in plug). Used for Light Gun games.
9ACKGreen Wire = pin 9 on control board

This applies to the Mad Catz. Dual force 2, programmable controller
for PSX, PSONE, and PS2. The control board pins are numbered, but if
unable to see due to the resin, pin one has a square PCB pad. If
looking at the control from underside, with the lower casing removed,
the pins can be counted sequentially from left to right. There should
be 9 in total. PLEASE NOTE: both purple and black wires are connected
to the same pin (pin 4) If the black wire is not connected, the vibrate
function will operate continuously.

Incoming search terms for the article:

PlayStation 2 Controller Cable Connector Pinout Diagram

Reprinted Url Of This Article: