Position: Index > Converter Circuit >

Positive voltage to negative voltage converter

2016-04-21 20:39  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

This circuit diagram shows how to obtain a negative voltage from a positive voltage supply. Another advantage of this circuit is that, the negative voltage together with the original positive supply can be used to simulate a dual supply. The circuit is based on timer IC NE555. The NE555 is wired as an astable multivibrator operating at around 1 KHz. The square wave output if available at pin no 3 of the IC. During the positive half of the square wave, capacitor C3 charges through diode D2.When the output of IC is at zero the C3 discharges through diode D2 and the capacitor C4 gets charged. As a result of this the voltage at the junction of the anode of D1 and cathode of C4 will be always negative with respect to the ground.
Circuit diagram.

positive to negative voltage converter


Assemble the circuit on a Vero board. The IC1 must be mounted on a holder. C3 and C4 must be rated at least 25V. Do not connect loads that consume more than 50mA current. The negative voltage output will be always a few volts lower than the positive supply.