Position: Index > Flash Circuit >

Flashing Heart circuit diagram

2017-02-01 07:56  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

This isLED  flashing circuit, the circuit is quite simple. Alternatively, you could be create another shape, not just heart shape.

Schematic diagram:

Flashing Heart circuit

Component list:

Resistors
R1, R2-470 ohm, 1/2-watt
R3-R5-100 ohm, 3-watt
R6-R8-1000 ohm, 1.4-watt
R9-5000 ohm potentiometer
   
Capacitors
C1, C2-100uF, 16 volts, electrolytic radial
   
Semiconductors
IC1-4047, low power monostable/astable multivibrator
Q1-Q3-2n3643 NPN transistor or equivalent
   
Diodes  
LED1-LED84-yellow light-emitting diode
LED85-LED126-red light-emitting diode
LED127-LED142-green light-emitting diode
   
Other components
PS1-12VDC @ 500mA wall transformer
   
Miscellaneous:Jumper wire, solder, printed circuit board,
drill and bits,14 pin I.C. socket, and a frame or case.

 

PCB layout:

Flashing Heart circuit

Component placement:

Flashing Heart circuit

Once power has been applied to the circuit, the Red LEDs should all be flashing on and off together. The Yellow LEDs should be flashing on and off, but only every other Yellow LED should be on at one time. The Green LEDs will stay on at all times. The flash rate can be adjusted by turning R9. Connections for a fixed value resistor for R9 are provided on the board layout if preferred.To dress up the project, a favorite photograph can be placed in the heart, and a frame can be made to fit the circuit board.

Complete explanation, pleasevisit this page

 





 


Reprinted Url Of This Article:
http://circuitdiagram.net/flashing-heart-circuit.html