Position: Index > Flash Circuit >

Neon Flasher Runs From 3V Supply(LT1111 )

2017-02-03 03:45  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

This article briefly describes the Neon Flasher Runs From 3V Supply (LT1111). This principle is easy to understand, but also very practical. Depth understanding of circuit elements, can be more effective to grasp this principle. Do you know the circuit, for example, can understand and buy these components: LT1111 , 1N4148.

A neon indicator typically requires at least 70V to fire it and normally would not be contemplated in a battery circuit. However, this little switchmode circuit from the Linear Technology website (http://www.linear-tech.com) steps up the 3V battery supply to around 95V or so, to drive a neon with ease. The circuit has two parts: IC1 operating as step-up converter at around 75kHz and a diode pump, consisting of three 1N4148 diodes and associated .022μF capacitors. The 3.3MO resistor and the 0.68μF capacitor set the flashing rate to about once every two seconds. The average DC level from the diode pump is set to about 95V by the 100MO feedback resistor to pin 8. The circuit could also use an LT1111 (RS Components Cat 217-0448) which would run at about 20kHz so L1 could be reduced to 100mH and use a powdered iron toroid core from Neosid or Jaycar.

Circuit diagram:

Figure:1 Neon Flasher Circuit Diagram

Figure 1 Neon Flasher Circuit Diagram

 

 


Reprinted Url Of This Article:
http://www.eeweb.com/blog/extreme_circuits/neon-flasher-runs-from-3v-supply