Position: Index > Flash Circuit >

Xenon flash trigger

2017-02-05 18:28  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

This circuit is used for remote photographic flash units that flash at the same time as the flash attached to the camera. This circuit is designed to the trigger cord or hot shoe connection of a commercial portable flash unit and triggers the unit from the light produced by the light of the flash unit attached to the camera. This provides remote operation without the need for wires or cables between the various units. The flash trigger unit should be connected to the slave flash before turning the flash on to prevent a d VIdt triggered flash on connection.

Xenon-flash-trigger 
 

TheL14C1phototransistor has a wide, almost cosine viewing angle, so aligmnent is not critical. If a very sensitive, more directional remote trigger unit is desired, the circuit can be modified using anL14G2lensed phototransistor as the sensor. The lens on this transistor provides a viewing angle of approximately 10?° and gives over a 10 to 1 improvement in light sensitivity (3 to 1 range improvement). Note that the phototransistor is connected in a self-biasing circuit which is relatively insensitive to slow-changing ambient light, and yet discharges the 0.01-I`F capacitor into the Cl06D gate when illuminated by a photo flash. For a physically smaller size, the C106D can be replaced by a C205D, if the duty cycle is reduced appropriately.
 

 



Reprinted Url Of This Article:
http://www.next.gr/video/camera-circuits/xenon-flash-trigger-l13572.html