Position: Index > Inverter Circuit >

DC to AC Inverter Using 555

2014-12-18 17:19  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

Circuit diagram DC-to-AC inverter AC output scheme at line frequency and voltage. 555 configured as a low frequency oscillator, melodious over the frequency range 50 to 60 Hz by Frequency potentiometer R4. 555 feed the output (amplified by Q1 and Q2) for the input of the transformer T1, a reverse-connected filament transformer with the necessary step-up turns ratio. Capacitor C4 and coil L1 filter the input to T1, assuring that it is a sine wave effectively. T1 value to adjust voltage. Output (in watts) is up to you to choose different components. Any input voltage from 5 V to 15 Volt DC, adjust the working voltage 2700uF cap fit. The following is a schematic drawing:

DC AC Inverter 555 sceme DC to AC Inverter Using 555

If not you can find replacement transistors for Q1 types are: TIP41B, TIP41C, NTE196, ECG196, etc. Replacement type for P2 is: TIP42B, TIP42C, NTE197, ECG197.

Parts List:

R1 = 10K
R2 = 100K
R3 = 100 ohms
R4 = 50K potmeter, Linear
C1, C2 = 0.1uF
C3 = 0.01uF
C4 = 2700uF
Q1 = TIP41A, NPN, or equivalent
Q2 = TIP42A, PNP, or equivalent
L1 = 1uH
T1 = Filament transformer, your choice

Note:

Q1/Q2 is oposites, e.i. npn / pnp.
You may be 555 damaged? Disconnect R3 from pin 3 and pin 3 to check the pulse.
Check the transistor to make sure they are not disabled


Reprinted Url Of This Article:
http://circuitdiagram-schematic.com/171/dc-to-ac-inverter-using-555/