Position: Index > Lamp Circuit >

A Bedside Lamp Timer Circuit (1N4002)

2016-08-03 04:56  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

This article briefly describes the A Bedside Lamp Timer Circuit (1N4002). This principle is easy to understand, but also very practical. Depth understanding of circuit elements, you can better grasp this principle. In this circuit, you can learn about and purchase these components: 1N4002.

30 minutes operation, BlinkingLEDsignals 6 last minutes before turn-off

The purpose of this circuit is to power a lamp or other appliance for a given time (30 minutes in this case), and then to turn it off. It is useful when reading at bed by night, turning off the bedside lamp automatically in case the reader falls asleep… After turn-on by P1 pushbutton, theLEDilluminates for around 25 minutes, but then it starts to blink for two minutes, stops blinking for two minutes and blinks for another two just before switching the lamp off, thus signaling that the on-time is ending. If the user want to prolong the reading, he/she can earn another half-hour of light by pushing on P1. Turning-off the lamp at user’s ease is obtained by pushing on P2.

Figure:1 A Bedside Lamp Timer Circuit Diagram

Figure 1 A Bedside Lamp Timer Circuit Diagram

Parts:

Resistors
R1 = 1K
R2 = 4K7
R3 = 10M
R4 = 1M
R5 = 10K

Capacitors
C1 = 470μF-25V
C2-C4100nF-63V

Semiconductors
C1 = 470μF-25V
C2-C4 = 100nF-63V
D1-D4 = 1N4002
D5 = 5mm. RedLED
IC1 = CD4012
IC2 = CD4060
Q1 = BC328
Q2 = BC547

Miscellaneous
P1,P2 =SPSTPushbuttons
T1 = 9 9 Volt Secondary 1VA Mains transformer
RL1 = 10.5V 470 Ohm Relay withSPDT2A 220V switch
PL1 = Male Mains plug
SK1 = Female Mains socket

Circuit operation:

Q1 and Q2 form anALL-ONALL-OFFcircuit that in the off state draws no significant current. P1 starts the circuit, the relay is turned on and the two ICs are powered. The lamp is powered by the relay switch, and IC2 is reset with a positive voltage at pin 12. IC2 starts oscillating at a frequency set by R4 and C4. With the values shown, pin 3 goes high after around 30 minutes, turning off the circuit via C3. During the c6 minutes preceding turn-off.

TheLEDdoes a blinking action by connections of IC1 to pins 1, 2 & 15 of IC2. Blinking frequency is provided by IC2 oscillator at pin 9. The two gates of IC1 are wired in parallel to source more current. If required, a piezo sounder can be connected to pins 1 & 14 of IC1. Obviously, timings can be varied changing C4 and/or R4 values.

 

 


Reprinted Url Of This Article:
http://www.eeweb.com/blog/extreme_circuits/a-bedside-lamp-timer-circuit-schematic