Position: Index > Led Circuit >

Automatic emergency light circuit

2014-12-07 23:46  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.
 

This low cost automatic emergency lighting circuit turns on a lamp during power failures. It is powered by a NiCad battery that is being charged by the main power line when there is no blackout. The circuit design is very simple and can be made by almost anyone.
How does the automatic emergency light works

The voltage from the step down transformer is rectified by diode D1 and filtered by C1. The NiCad battery gets charged with about 100 mA via the diode D2 and resistor R1. The battery must have a capacity of at least 2 Ah to tolerate the charging rate.

When the main power supply fails during a blackout, the charging current is interrupted and a current flows from the base of T1 via resistor R2 which triggers the transistor to conduct and the two emergency lamps light up. When the main power returns, the charging current flows again through D2 and the transistor turns the lamps off.

The “TEST” button S1 is used to check the function of the circuit. If the secondary coil of the transformer delivers a higher voltage level, replace R1 with a higher value resistor to avoid exceeding the maximum charging current allowed for the NiCad battery being used.

Emergency light parts
220V to 4.5V / 2A Transformer
D1 = 1N4004
D2 = 1N4001
R1 = 33Ω/1W
R2 = 470Ω
C1 = 470µF/16V
T1 = 2SB242
La1, La2 = 2.5V bulbs
Battery = 2.5V / 2Ah Nicad

Automatic Emergency Lighting Circuit Diagram

automatic emergency light circuit schematic

 


Reprinted Url Of This Article:
http://electroschematics.com/6199/automatic-emergency-light/