Position: Index > Led Circuit >

Gu10 led light bulbs driver using LNK605DG

2014-12-20 18:06  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

A very simple high efficiency Gu10 led light bulbs driver power supply circuit that can be used as a LED driver for driver for GU10 lamp can be designed using this schematic circuit .
This high efficiency Gu10 led light bulbs LED driver is designed to drive 12 V at 0.3 A from an input voltage range of 90 VAC to 265 VAC using few external components. For this electronic project is very important the dimension of the pcb and how many components are used , because you will need to mount the PCB into a small support .
This Gu10 led light bulbs driver power supply ( LED driver ) for GU10 lamps uses the LNK605DG IC from the LinkSwitch-II family by Power Integrations.
The LNK605DG provides a sophisticated range of protection features including auto restart for open control loop and output short-circuit conditions. Accurate hysteretic thermal shutdown ensures safe average PCB temperatures under all conditions. Typically output current and output voltage is 0.3A respective 11 volt . As you can see in the circuit diagram , this LED driver require few external electronic components .

Laptop power supply TOP269EG L4970A L4974A power supply coil coresHigh current power supply diagram using L4970A L4974A 5-12V 12 to 220 volts voltage converter circuit electronic project Automatically disconnect power supply circuit diagram

The LNK605DG Ic from LinkSwitch-II family is an integrated controller plus 700 V power MOSFET intended for use in LED driver or charger applications. The LinkSwitch-II is configured for use in a single-stage discontinuous conduction mode flyback topology and provides a primary side regulated constant voltage and current output.
The rectified and filtered input voltage is applied to one end of the primary winding of T1 transformer and the other side of the transformer’s primary winding is driven by the integrated 700 V power MOSFET in U1. The leakage inductance drain voltage spike is limited by an RCDR clamp consisting of D1, R3, R4, and C3.

The secondary of the transformer is rectified by D3 ( a Schottky barrier type was selected for higher efficiency) and filtered by C7.
Resistor R1 and C6 dampen high frequency ringing and reduce the diode voltage stress.
The T1 transformer must have 30 turns from NC to pin1( with 0.221 mm copper wire) , 80 turns from pin1 to pin 2 ( with 0.15 mm copper wire) , 15 turns from pin7 to pin8 ( with 0.4mm copper wire) and 16 turns from pin A to pin B (using 0.2mm copper wire ) .
Gu10 led light bulbs driver circuit schematic using LNK605DG