﻿ Interactive Toy Traffic Lights(74C14)_Circuit Diagram World ﻿
Position: Index > Led Circuit >

# Interactive Toy Traffic Lights(74C14)

2014-12-23 17:03
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

This article briefly describes the Interactive Toy Traffic Lights (74C14). This principle is easy to understand, but also very practical. Depth understanding of circuit elements, can be more effective to grasp this principle. Do you know the circuit, for example, can understand and buy these components: 74C14 , 1N4148.

This toy traffic signal uses a single low-cost hex Schmitt-trigger inverter IC (IC1a-IC1f) to directly drive three colouredLEDs (red, green and amber). At switch-on, the circuit lights the red signal for 30s, then shows green for 6s, then amber for 3s. It then repeats the sequence. Interaction is provided by pushbutton S1 which abbreviates the red period to a further 3s only, if it is pressed while the red signal is showing. Sequencing of the threeLEDs is controlled by inverters IC1c, IC1d & IC1e, while the electrolytic capacitors at the inverter outputs and their associated 2.7MO resistors determine how long eachLEDstays on.

Diodes D3, D4 & D5 discharge the timing capacitors for the next twoLEDs in the sequence while the currentLEDis on. Note also the 10kO resistor at the input of each inverter. These protect the inverter inputs from being damaged by the negative voltage produced when the previous output goes low while its timing capacitor is fully charged. The circuit is forced into the red state at switch-on by IC1f and its associated circuitry. What happens is that IC1f briefly pulls the negative end of the amber timing capacitor (C4) low via D6 at switch-on. As a result, IC1e’s output goes high and turns the amberLED(LED3) off.

#### Figure 1 Interactive Toy Traffic Lights Circuit Diagram

The red timing capacitor (C5) is in a discharged state at power-up because D5 and the 10kO resistor at the output of IC1e discharge it when the power is off. As a result, when IC1e’s output goes high, IC1c’s output goes low and turns LED1 (red) on. This also pulls the input of IC1d low, so IC1d’s output goes high, turning the greenLEDoff. The amber timing capacitor (C4) at the output of IC1d charges rapidly when it receives the negative pulse from IC1f. That’s because its positive end is high when the greenLEDis off and the pulse takes its negative end low. When pin 12 of IC1f subsequently goes high at the end of the switch-on pulse, this remains charged and holds the input of IC1e low, so the amberLED(LED3) remains off.

Pushbutton operation is controlled by IC1a and IC1b, which rapidly charge the red timing capacitor (C5) 3s after switch S1 is pressed. This works as follows: pin 2 of IC1a is high when the redLEDis on, so pressing S1 during the red period rapidly charges C1. C2 then charges slowly from C1 via a 2.7MO resistor. After about 3s, C2 reaches IC1b’s trigger threshold and so pin 4 of IC1b switches low. Because the redLEDis on, the amberLEDis off. This means that pin 10 of IC1e is high and so the positive end of C5 is also high. When IC1b’s output goes low, it pulls the negative end of C5 low via D2, thereby rapidly charging this timing capacitor. This ends the red period and so the redLED(LED1) turns off. As a result, IC1a’s output goes low and C1 and C2 discharge via D1, ready for the next time switch S1 is pressed.