Position: Index > Led Circuit >

Touch Controlled Amplifier

2014-12-14 14:42  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

touch controlled amplifier circuit diagram


Touch Volume Controlled Amplifier Circuit

Nowadays touch control techniques are becoming quite popular. They give better appearance to the control panel and are silent in operation. The circuit described here enables to control volume of the amplifier by simply touching corresponding touch pads. As there is no mechanical contact it is superior to the normal potentiometer type control. Its response is similar to the logarithmic response of human ears. It gives visual indication of the volume level by means of a single LED.

touch controlled amplifier circuit

PARTS LIST
R12.2MΩ
R2100KΩ
R3100KΩ
R4100KΩ
R51KΩ
R6100Ω
R722Ω
R8
R9100KΩ
VR11KΩ
C12μF 250V POLYESTER
C2470μF 10V
C30.1μF
C4100μF 25V
C5100μF 25V
C66.8Kp (6800pF)
C7100μF 25V
C81000μF 25V
C91.5Kp (1500pF)
C100.1μF
D1LED
D25.1V 400mW
T1CD 4007
T2
IC1TBA 810
LS4Ω 20W
ABCTOUCH PLATES

The heart of the circuit is a CMOSE IC CD4007 which comprises a dual complementary pair of MOSFETs and an inverter. It is not generally used in digital applications. Its Pin configuration is shown in Fig.2 and the complete circuit diagram of the system is shown in Fig.1. Two separate n-channel MOSFETs, T1 and T2, are used in this circuit. T2 acts as a voltage controlled attenuator and the control voltage is provided by T1. Gate to source voltage of T2 determines its drain to source resistance (Rds). It can be varied in the range of a few hundred ohms to several mega ohms.

tba810 ic viewtba810 pin connection diagram
TBA810 IC Top ViewTBA810 Connection Diagram

Now, consider the circuit operation. Initially there is no charge on C1 and Rds of T1 is maximum. So T2 gets full voltage and all the input signals appear across R4. Hence, the volume level of the amplifier is minimum. As C1 is charged by touching points A and B, the Rds of T1 decreases and volume increases as the control voltage of T2 decreases. Input resistance of T1 and T2 is of the order of 1012ohms. So, the charge on capacitor C1 is hardly affected for an hour or two and the operation is stable.

Here IC1 is used as a power amplifier capable of delivering up to seven watts tms. However, for higher amplification any power amplifier having low input sensitivity may be used.

cd 4007 IC top view

CD 4007 IC Top View

For setting VR1, short points A and D momentarily, provide input signal and adjust VR1 for maximum output. C1 should be a non-polarised polyester capacitor and its leakage current should be minimum. Gate and source (pin nos. 6 and 7) of? T1 are physically close, so even dust particles will form discharge path for C1. This should be avoided. Finally, capacitor charging rate can be increased or decreased by changing the value of R1. It also depends upon personal touch and skin resistance.


Please send your ideas, which are very important for our success…

Share


Reprinted Url Of This Article:
http://www.electronicecircuits.com/electronic-circuits/touch-controlled-amplifier