Position: Index > Monitor Circuit >

Monitoring Circuit for Telephone Line Usage

2015-01-22 06:52  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.
Figure:1

Figure 1 

The circuit was designed to provide a monitoring scheme for a telephone line where several phones are installed, to indicate when one is being used.

4N25 – a general purpose optocoupler that consists of a gallium arsenide infrared emitting diode driving a silicon phototransistor in a 6-pin dual in-line package used in microprocessor inputs, digital logic inputs, and power supply regulators due to its features such as high isolation voltage between input and output, operating temperature up to 110oC, and available in wide-lead spacing4011 – a quad 2-inputNANDgate integrated circuit, generally characterized by small fluctuation in voltage supply, very high impedance, outputs that can sink and source, one output can drive up to 50 inputs, high speed gate propagation time, high frequency, and low power consumption7812 – 3-terminal 1A positive voltage regulator with short circuit protection, thermal overload protection, output transistor safe operating area protection, output current up to 1A, and output voltages from 5V to 24V

The circuit is not only useful in indicating a phone being used but it can also cut from a stereo amplifier some certain sounds that are too high, some sound of the television, or turn ON some light when a telephone rings that needs to be answered or unhooked. Included in the circuit is a pair of 12 V 2X2 relay contacts RL1 that are connected to a 2-pin connector 2.54 mm step J2. This can be used when connecting any appliance or equipment that is desired. The telephone line will be connected to J1 having the required polarity.

The unused or idle state of the telephone will possess a voltage of about 48 V to 50 V. the photodiode is activated by this voltage while IC1 isolates the circuit from the telephone line at the same time. The photodiode is capable of converting light into either voltage or current depending on the operation method while a phototransistor is more sensitive to light than a photodiode and produces more current output for a given light intensity. As the phototransistor turns ON in the IC1, the input of IC2A will become low while the output will become high since it is aNANDgate. This would then lead to a high input at IC2B through the delay circuit consisting of R4, R5, C1, and D6 and thus, having a low output. This would cause transistor Q1 to beOFFwhile relay RL1 is not active.

Upon raising the telephone, the telephone line voltage will drop to 6 V to 10 V. this would cause all the operation to work in reverse direction where RL1 will be turned ON. The duration that determines when the RL1 is closed or open depends on the type of telephone being used like the dial choice between disk or pulse system. The use of the delay circuit is to ensure the stability in the operation of RL1 as it is located between the gates of IC2A and IC2B and delays the changes on the input of IC2B. The relay RL1 will get activated when the telephone rings or the handset is raised, as long as the value of resistor R4 is 100K ohms. Changing the value of R4 to 1M ohms will cause the relay to be activated only when the handset has been raised. The circuit can be considered as a simple regulator due to its operation, while having a voltage of 12 V.

Figure:1

Figure 2 

The usage of the circuit does not only focus on indicating if a telephone on the network is using the line to avoid interruptions where aLEDis used as an indicator. It can also be a triggering point for other appliances in the house or office to perform certain operations and functions that is desired by the user.

Source:users.otenet.gr/~athsam/telephone_line_monitor.htm


Reprinted Url Of This Article:
http://www.circuit-projects.com/miscellaneous/monitoring-circuit-for-telephone-line-usage.html