Position: Index > Monitor Circuit >
Single-supply-fault-monitor
2015-01-24 09:40
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.
This circuit shows a typical over/under-voltage fault monitor for a single supply. The upper trip points, controlling OUT 1, are centered on 5.5 V with 100 mY of hysteresis Wu = 5.55 V, `L = 5.45 V); and the lower trip points, controlling OUT 2, are centered on 4.5 V, also with 100 mV of hysteresis.
 |
Reprinted Url Of This Article:
http://www.next.gr/power-supplies/ac-dc-dc-dc/single-supply-fault-monitor-l13627.html
Maybe you like
Similar Circuit Diagram
- AdvancedTCA Four Fuse Monitoring Application
- Full-Bridge Load Current Monitor
- Bidirectional Battery-Current Monitor
- Current-monitor-and-alarm
- Monitoring and Detection of Temperature
- Calibration and monitoring sensors
- Enlarge Ear Monitoring Circuit Introduction
- Single-Cell Voltage Monitor CIRCUIT (IRFB3207ZPBF)
- Monitor Life Extender(TLC555)
- The third generation of car battery monitoring
- Automotive battery monitor circuit
- Supply Voltage Monitor (TIL209)
- Plant-water monitor
- LT1991 Individual Battery Cell Monitor for a 4-Cell Battery
- 12V Lead-Acid Battery Monitor circuit diagram
- Line-current-monitor
- PC Heat Monitor(LL4148)
- Battery Level Monitor circuit
- Intelligent temperature monitoring and control system using
- Energy Consumption Monitor Circuit
- Duty-cycle-monitor
- Fuse Monitor / Alarm
- High Voltage/Current and Temperature Monitoring
- Relaxation or Stress Monitor Project
- How to build Battery Equality Monitor Circuit Schematic