Position: Index > Phone Circuit >

Cellular Phone calling Detector (1N5819)

2016-02-09 11:34  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

Flashes a LED when detecting an incoming call

Circuit diagram:

Cellular Phone calling Detector

Parts:

R1____________100K   1/4W Resistor
R2______________3K9  1/4W Resistor
R3______________1M   1/4W Resistor

C1,C2_________100nF   63V Polyester Capacitors
C3____________220µF   25V Electrolytic Capacitor

D1______________LED  Red 10mm. Ultra-bright (see Notes)
D2___________1N5819  40V 1A Schottky-barrier Diode (see Notes)

Q1____________BC547   45V 100mA NPN Transistor

IC1____________7555 or TS555CN CMos Timer IC

L1_____________Sensor coil (see Notes)

B1_____________1.5V Battery (AA or AAA cell etc.)

This circuit was designed to detect when a call is incoming in a cellular phone (even when the calling tone of the device is switched-off) by means of a flashing LED.
The device must be placed a few centimeters from the cellular phone, so its sensor coil L1 can detect the field emitted by the phone receiver during an incoming call.

The signal detected by the sensor coil is amplified by transistor Q1 and drives the monostable input pin of IC1. The IC’s output voltage is doubled by C2 & D2 in order to drive the high-efficiency ultra-bright LED at a suitable peak-voltage.

This article describes a Cellular Phone calling Detector (1N5819). The content is very simple, very helpful. Components in this article can help you understand better understanding of this article. For example, in this article, you can go to find and buy these components:1N5819.


Reprinted Url Of This Article:
http://wiringdiagramcircuit.com/cellular-phone-calling-detector/