Position: Index > Phone Circuit >

Wireless-fm-microphone

2016-02-01 17:44  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.


Transistor Q1 acts as an amplifier for condenser microphone MIC1. The output of Q1 is applied to the base of transistor Q2 through a 4. 7 -I`F capacitor. C2 and 11 form an LC tank circuit. which is used to set the frequency at which the transmitter operates. Coil 11 is a variable inductor, centered a bit below 1~tH, that is used to adjust the modulating frequency of the circuit. Capacitors C1 and C2 are 4. 7 pF units. A lower value can be used to raise the circuit`s operating frequency. The microphone and Q1 provide a varying voltage at the base of Q2, with the output of Q2 applied to the LCtank circuit.
Wireless-fm-microphone

That causes a modulating action in the tank circuit that, when applied to the antenna, a short piece of wire 6-to 8-inches long, will provide a good, clear FM signal somewhere in the range of 88 to 95 MHz with a range of about 100 feet.



Reprinted Url Of This Article:
http://www.next.gr/rf/fm-transmitters/wireless-fm-microphone-l13817.html