﻿ 555 Low power Consumption Timer Circuit_Circuit Diagram World ﻿
Position: Index > Power Supply Circuit >

# 555 Low power Consumption Timer Circuit

2015-03-24 12:39
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

# 555 Low power Consumption Timer Circuit

Normally 555 timer circuit even though the start push-button PB1 is not pressed, the timer keeps consuming power From the battery due to a potential divider formed by three 5kΩ? resistors within the IC. this power consumption known as the idling power consumption of the timer is about 3mA. This, if left connected to a battery for a long time can drain off the battery and may give unreliable operation.

To deviate this short coming, you may use the circuit given in the below. Which enables power to be drained from the battery only when timing action is ON. For the idling period, the power consumption is zero.

 PARTS LIST R1 10kΩ R2 1kΩ R3 100kΩ Preset C1 100μF 16V C2 0.01μF D1 1N4001 D2 1N4001 RL1 12V Double Pole Relay PB1 Push to ON Push-Button Switch IC1 NE555

The circuit uses a double pole relay. One pole is used to energize the? load, the other pole is used to cut off the supply line when the timing action is over.

A push on the ‘Start’ switch energizes the relay RL1. A pair of contacts of the relay provides the supply voltage to the timer which get triggered. Oscillations start and when the output at pin 3 becomes HIGH, the diode D1 permits current to flow through the relay, thus “latching” it up. The frequency of the oscillations depends on the time constant given by T=1.1×C1×(R1 R3). After this time is over, the output at pin 3 goes LOW; the relay is released, and the load is de-energized.

Thus, so long as the start switch is not pressed, no supply voltage is provided to the IC and so, its “idling” power consumption is zero.