﻿ Notebook Power Car Adapter 19 Volt_Circuit Diagram World ﻿
Position: Index > Power Supply Circuit >

Notebook Power Car Adapter 19 Volt

2015-03-16 08:45
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

Car cigarette lighter output DC voltage is 12 V, even when the engine is running will not exceed 13 .8 V, 19 V voltage lower than the normally required of notebook computers. The boost converter voltage conversion, the basic circuit shown in Figure 1, which consists of power switch T, diode D, the energy storage inductor L, and filter capacitor C The inductance constantly charge and discharge, the induced voltage is added to the resulting output voltage on the power supply voltage higher than the voltage provided by the car cigarette lighter.
Diagram Circuit: (1) S conduction, D, cut-off: the input DC power UIN IIN current pathway formed by the inductance coil L and switch S DC power charging the inductor, the inductance L of the current linear increase in electrical energy to magnetic energy stored in the coil. At this point, the diode D is reverse biased, and output load current IOUT from the energy stored in the capacitor C, as shown in Figure 2 (a) below.

(2) S off: D conduction due to the inductance L of the current can not jump, induced in the coil shown by a very sexy raw voltage. Therefore, the polarity of the induced voltage is left negative right being. The diode D into forward state, the original through the diode D in S during the conduction of the energy stored in the inductor coil to the capacitor C and load RL. C at this stage, the energy charge in the next S period ending provided to the load RL.
The boost converter in the power switch S, one in the state of switch power MOSFET tube. Gate with a series of pulse power tube in the state and off alternately, changing the ratio of off time, you can adjust the size of the output voltage. Suppose that a cycle t, t = tON when the positive pulse, pulse width modulation pulse was sent to the gate of power transistor K conduction; when t = M1 is turned OFF (tOFF), modulation pulse sent to the K tube into the zero volt or negative bias, S in a closed state.

Author : Anonymous

Source : 182e.com

Incoming search terms for the article:

12 volt to 19 volt laptop converternotebook car power