﻿ Up/Down Timer For A Power Antenna(BC337)_Circuit Diagram World ﻿
Position: Index > Power Supply Circuit >

# Up/Down Timer For A Power Antenna(BC337)

2014-11-08 13:38
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

This article describes the Up / Down Timer For A Power Antenna (BC337). The principle is very simple, very practical. The circuit components can help you understand better grasp this principle. For example, in this circuit, you can go to find and buy these components: BC337.

This up/down timer was designed to control a power antenna on a late-model vehicle. Normally, this vehicle uses a body computer to control the antenna. However, the person who owned the vehicle wanted to install his own high-powered audio stereo system. The original stereo system was tied in with the body computer and this meant that a separate antenna controller was required for the after-market sound system. Also, the power antenna fitted did not have limit switches inside, hence the need for a timed control circuit. Here’s how the circuit works. first, assume that the radio antenna control output is not switched on – ie, the radio is switched off.

In that case, relayRLYCwill be off and so relayRLYAwill also be off, as is the motor. Conversely, when the radio is switched on, the radio antenna control output line switches to 12V. And when that happens,RLYCcloses its contacts and applies power to the circuit. As a result, C2 (330OF) quickly charges via D4, while Q4 is biased on via D5 and R5. This ensures that Q3 and relayRLYBremain off. At the same time, Q2 is is turned on, thus turning onRLYAand applying power to the motor. This drives the antenna in the up direction. During this time, C1 charges via R2.

Circuit diagram:

#### Figure 1

When the voltage across the capacitor reaches 8.1V, Q1 turns on via ZD1 and so Q2 turns off and switches off the relay – ie, this gives the “up” timeout. Using the values shown for C1, R2 and ZD1 gives an “up” duration of approximately 6 seconds – long enough to fully extend the antenna. D1 discharges C1 (via resistor R1) when the 12V supply is later removed. When the radio is switched off (or a CD placed into the stereo unit), the radio antenna control output switches back to 0V. This does several things: first, it turns Q4 off and this allows Q3 to turn on due to the stored charge in C2. Q3 andRLYBnow turn on for about six seconds – ie, while C2 discharges via R4 – and this switches power to the motor in the opposite direction to drive the antenna down. Diodes D4 and D5 are there to prevent C2 from discharging back via the circuitry around on Q1 and Q2.