Position: Index > Sensor Circuit >
Liquid level Alert
2014-11-28 00:40
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.
This circuit will emit an intermittent beep (or will flash a LED) when the water contained into a recipient has reached the desired level. It should be mounted on top of the recipient (e.g. a plastic tank) by means of two crocodile clips, acting also as probes. If a deeper sensing level is needed, the clips can be extended by means of two pieces of stiff wire. visit page.
IC1, a 555 CMos timer chip, is wired as an astable multivibrator whose operating frequency is set by C1, R1 and R2, plus the resistance presented by water across the probes. If the resistance across the probes is zero (i.e. probes shorted), the output fre visit page.
Maybe you like
Similar Circuit Diagram
- the constant voltage-driven bridge sensor circuit constitute
- Permeating Optical Interrupter Structure And Circuit
- Humidity Sensor with the H14DL
- Across The Track Infrared Detectors
- Temperature sensor and DVM interface
- A brief overview of Allegro ACS712 current sensor. Part 2 -
- Low voltage detector
- Flood alarm
- LATCHING_WATER_SENSOR
- Simplified scheme of vibration sensor using a CA3094
- Small Metal Detector II
- Infrared (IR) Proximity (Distance) Sensor CIRCUIT (MAX4230)
- Motion Sensor Switch for alarm, light or water sprinkler
- Temperature_senstive_heater_control
- Heartbeat Sensor (Tranduscer)
- Gas-temperature-monitor-detection
- Data Line Remote Short Sensor
- Battery Current Sensor
- Rain alarm-door bell
- The Good Helper for Pressure Sensor ? DIY Force Sensitive Re
- A brief overview of Allegro ACS712 current sensor. Part 1 -
- Buffering TMP01 Temperature Sensor
- Data Line Remote Short Sensor
- Dark Activated Switch circuit
- Dew sensor principle Commentary