Position: Index > Simple Circuit >

Simple Serial AVR Programmer (ATmega103)

2015-01-09 18:48  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

This article describes the Simple Serial AVR Programmer (ATmega103). The content is very simple, very helpful. Components in this article can help you understand better understanding of this article. For example, in this article, you can go to find and buy these components:ATmega103. 

This simple AVR Programmer able to transfer hex programs to most
ATMEL AVR microcontrollers. It is more reliable than most other simple
AVR programmers available out there and can be built in very short
amount of time.
This Programmer support the AVR microcontroller ATmega103, ATmega161,
ATmega163, ATmega 323, ATmega128, ATmega8, ATmega16, ATmega64, ATmega32,
ATmega162, ATmega169, ATmega8515, ATmega8535,ATmega44, ATmega88,
ATmega168, ATmega164, ATmega324, ATmega644, ATmega640, ATmega1280,
ATmega1281, ATmega2560, ATmega2561, AT90can32, AT90can64, AT90can128,
ATtiny12, ATtiny15, ATtiny26, ATtiny2313, ATtiny13, ATtiny25, ATtiny45,
ATtiny85, ATtiny261, ATtiny461, and ATtiny861.

Simple Serial AVR Programmer Simple Serial AVR Programmer
This AVR programmer consists of a serial in-circuit programmer (dongle)
and a small PCB with DIP sockets where you can fit your microcontroller.

you can also use it directly in the main circuit by adding a pin to
plug this cable programmers, so you do not need to remove the chip while
it is to program.
The PCB connector has been created to match the ATmega8 AVR
microcontroller, 28-DIP, but you can build a PCB socket for each other
AVR microcontroller out there. This AVR programmer software is
compatible with popular PonyProg showing the status bar the progress of
programming.

Simple Serial AVR Programmer1 Simple Serial AVR Programmer

This bellow the minimum system programming.

Simple Serial AVR Programmer3 Simple Serial AVR Programmer
This minimum system schematics using crystal 4 Mhz, you can use other
crystal frequency depend on your fuse bit setting, please be careful
when setting fuse bit and security lock. if you wrong .. you can’t
recovery your chips and your chips will damage. expected, you have High
voltage programmer.
this bellow Step by Step to program using Ponyprog
1. Download this software from this link and install.
2. open program and goto to Menu Setup >> Interface setup
pony prog interface setup Simple Serial AVR Programmer

3. Chose device like this picture
chose device Simple Serial AVR Programmer

4. Open Hex file , using button icon Open .
open hex file Simple Serial AVR Programmer

5. setting Security and configuration Bit , chose menu “Command >> Security and Bit Configuration”
setting like this sample .

6. Run flash program Icon Button or chose menu “Command>> Write ALL” or Ctrl W
7. Verify that is hex file flashing on your chip using Menu
“Command>> Verify All” or “Command >> Verify Program (FLASH)