﻿ Simple Transistor Tester Using 555 IC_Circuit Diagram World ﻿
Position: Index > Simple Circuit >

# Simple Transistor Tester Using 555 IC

2015-01-08 06:26
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

Testing whether a transistor is shorted or open usually done by ohm meter. You test if the base to emitter or collector permit a current flow in one direction. Here is the circuit’s schematic diagram:

The  555 timer  ( IC1 ) operate as a 12hz oscillator. The output of this oscillator (pin 3) drives the 4027 flip-flop (IC2). Clocked by the oscillator, this flip-flop give complementary voltage outputs on pin 15 and 14. The outputs drives LED1 and LED2 through the current limiting resistor R3. The LED’s are arranged so that if the polarity across the circuit is one way then only one LED will light and if the polarity reverses then the other LED will light, and? when no transistor is connected to the tester then the LED’s will alternately flash. The IC2 outputs are also connected to resistors R4 and R5 with the junction of these two resistors connected to the base of the transistor being tested. If a good transistor connected to the tester, the transistor will turn on and produce a short across the LED pair. If a good NPN transistor is connected then only LED1 will flash. If a good PNP transistor is connected then? only LED2 will flash. If the transistor is open both LED’s will flash and if the transistor is shorted then neitherLEDwill flash.

After receiving a feedback from our reader, I’ve checked the datasheet of  4027  JK flip-flop, and found that the pin 12 and 13 in the schematic diagram above should be interchanged. Here is the feedback:

Hi

I am writing in reference to the circuit on the below link:
http://freecircuitdiagram.com/2008/08/21/simple-transistor-tester-using-555-ic/

• The connection between the 555 and the 4027 is wrong. The JK needs to be Clocked in order to work which is pin 13 on the 4027. Pin 12 is the Reset and will not achieve anything. To summarise pin 12 needs to be grounded and pin 13 is connected to the 555′s output.

I hope you find this useful, and having more working circuits will add credibility to your site.

(Bart)