Position: Index > Simple Circuit >

Simplest atmega8 programmer Using LPT Port

2015-01-09 11:30  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.


* R1-R4 = 220R

Atmega 128 is like other AVR microcontrollers. They are ISP – is in-system programmable. Earlier I wrote an article about AVR ISP programmer where 74HC244 buffer is used. Using buffer is safer for your AVR.

But what if you need 128 atmega programmer without any parts, then you can connect your microcontroller directly to LPT port or use protection resistors (220R) just in case. of course circuit works without resistors, but you put your LPT port at risk.

Just connect GND, SCK, MISO, MOSI and RESET to adequate LPT pins and you can program atmega’s flash memory without removing it from socket. Programming software can be PonyProg. you also need power supply 5v Vcc For IC. if you Using PonyProg make sure the setting like this .

Section DOWNLOAD:

PonyProg

Incoming search terms for the article:

atmega8 programmerponyprogatmega8 parallel programmeratmega8 lpt programmerlpt programmerprogramator avr lptLPT atmega8programator atmega8atmega8atmega8 usb programmer


Reprinted Url Of This Article:
http://makecircuits.com/blog/2009-03-23-simplest-atmega8-programmer-using-lpt-port.html