Position: Index > Switch Circuit >

High performance video switch

2015-10-05 18:05  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

This figure shows a one-of-two switch with a sunnning amplifier. The video source`s line can be terminated either externally or internally to switch RO. With this termination resistor, a load change of less than 10 will be seen by the source when the switch changes state. For this reason, input isolation amplifiers are not necessary. R4 can be varied to control circuit gain, but should never be less than 14000 since theNE5539is internally compensated for gain values greater than seven.

High-performance-video-switch 
 

A value of approximately2500 {}for R4 will set circuit gain to near unity. Additionally, the circuit output impedance is set by R6, and R5 sets the output de offset to near zero.