﻿ Petrol Gas Switch For A Pajero (LM324)_Circuit Diagram World ﻿
Position: Index > Switch Circuit >

# Petrol Gas Switch For A Pajero (LM324)

2015-10-15 01:52
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

This article describes the Petrol Gas Switch For A Pajero (LM324). The principle is very simple, very practical. The circuit components can help you understand better grasp this principle. For example, in this circuit, you can go to find and buy these components: LM324.

My current vehicle, a Pajero, was modified for dual fuel – ie, petrol and gas. However, it’s necessary to run the vehicle on petrol at regular intervals to stop the injectors from clogging up. This simple circuit allows the vehicle to be started using petrol and then automatically switches it to gas when the speed exceeds 45km/h and the brake pedal is pressed. Alternatively, the vehicle may be run on petrol simply by switching the existing petrol/gas switch to petrol. You can also start the vehicle on gas by pressing the brake pedal while starting the vehicle. The circuit is based on an LM324 dual op amp, with both op amps wired as comparators. It works like this: IC1a buffers the signal from the vehicle’s speed sensor and drives an output filter network (D1, a 560kO resistor and a 10μF capacitor) to produce a DC voltage that’s proportional to the vehicle’s speed.

Circuit diagram:

#### Figure 1

This voltage is then applied to pin 5 of IC1b and compared with the voltage set by trimpot VR1. When pin 7 of IC1b goes high, transistor Q1 turns on. This also turns on transistor Q2 when the brake pedal is pressed (pressing the brake pedal applies 12V from the brake light circuit to Q2’s emitter). And when Q2 turns on, relay 1 turns on and its contacts switch to the gas position. Trimpot VR1 must be adjusted so that IC1b’s pin 7 output switches high when the desired trigger speed is reached (ie, 45km/h). In effect, the speed signal isAND’ed with the brake light signal to turn on the relay. The vehicle has been running this circuit for several years now and is still running well, with no further injector cleans required.