Position: Index > Transistor Circuit >

Build an op amp with three discrete transistors

2016-05-08 21:00  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

Lyle Russell Williams, St Charles, MO

You can use three discrete transistors to build an operational amplifier with an open-loop gain greater than 1 million (Figure 1). You bias the output at approximately one-half the supply voltage using the combined voltage drops across zener diode D1, the emitter-base voltage of input transistor Q1, and the 1V drop across 1-MΩ feed-back resistor R2.

???????????? ????????? ?? ???? ?????????? ????????????
Figure 1.This ac-coupled inverting op amp has an open-loop gain of 1 million. R1and R2set a closed-loop gain of −10.

Resistor R3and capacitor C1form a compensation network that prevents the circuit from oscillating. The values in the figure still provide a good square-wave response. The ratio of R2to R1determines the inverting gain, which is −10 in this example.

You can configure this op amp as an active filter or as an oscillator. It drives a load of 1 kΩ. The square-wave response is good at 10 kHz, and the output reduces by 3 dB at 50 kHz. Set the 50-Hz low-frequency response with the values of the input and the output capacitors. You can raise the high-frequency response by using faster transistors and doing careful layout.

EDN


Reprinted Url Of This Article:
http://www.radiolocman.com/shem/schematics.html?di=136010