Position: Index > Transmitter Circuit >

200mW FM Broadcast Transmitter

2016-04-01 01:31  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.
200mW FM Broadcast Transmitter

 

200mW FM Broadcast Transmitter

 


A simple 200mW FM Transmitter circuit which covers frequencies from 88 to 108 MHz. It is built with 3 transistors: BC109, BFR91A and BFR96S. It is quite stable and the output power is around 200mW. The first stage of transmitter is a mic amplifier but if you connect this radio transmitter directly to an audio source you can remove this stage and connect the audio signal to R5. U1, 1PH51C can be replaced with LM7805. You must use a stabilized power source for oscillator stage to prevent frequency variation. You can remove C7 and use a linear potentiometer instead of R6 with the median connector to C4, one pin to ground and the other one to . FM Transmitter uses MV2109 varicap diode and C7 for frequency tuning.


All coils must be perpendicular one to the other, especially L2 and L3. The oscillator stage must be encased with a copper 1mm foil. If you use an external antenna, like fm dipole antenna connect it with a good coaxial cable because the power is low and you want to use most of it. If you don?t want to loose the RF power connect the radio transmitter close to the antenna (2 meter coaxial cable) and use a longer cable for the audio signal (coaxial). If you connect the antenna as I told you before you can cover larger diameter area.








Reprinted Url Of This Article:
http://electronics-diy.com/200mw-fm-transmitter.php