Position: Index > Transmitter Circuit >

Basic low power AM transmitter

2016-04-01 23:53  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.


This transmitter?is basic but allows transmission of audio to an AM radio. It consists of an RF?oscillator operating in the AM broadcast band, together with a modulator stage,?which mixes the incoming audio and the RF. A signal appears on the output, which?has an AM component that can be picked up on a nearby AM radio receiver. The transmitter consists of?oscillator stage Q1 and modulator/buffer stage Q2. Q1 is biased via R1, R2, and R3.?L1, C3, and C4 form the tank circuit with feedback network C3-C4 providing feedback?to the emitter of Q1. RF voltage at the junction of C3 and L1 drives buffer/modulator stage Q2. Q2 is biased by base current produced by RF rectification in the?base emitter junction of Q2. C6 is an RF and AF bypass capacitor. C9, C10, and L2?form the tank circuit for the collector of Q2. RF is taken from the junction of C9 and?C10 and fed to a?short-wire?antenna. Audio is fed to modulator Q2 via C8 and isolation?resistor R5 and mixes with the RF signal in the collector circuit of Q2, producing?a signal that has sum and difference frequencies if the RF carrier and AF input ?along with the carrier signal. An AM signal appears at?the collector of Q2. Audio with an RMS voltage equal to about 0.7 times the collector?voltage of Q2 is needed for full modulation of the output.?Because of the high level of audio needed, the modulation obtained from this circuit?is somewhat limited with conventional audio sources because several volts of?audio into a few hundred ohms is needed. The circuit demonstrates the principle of?an AM transmitter, however, and with a suitable audio drive level, produces a well modulated?AM signal.5 Responses to “Basic low power AM transmitter”