Position: Index > Unclassified >

13V/2A PSU For Handheld Rigs(LM723)

2017-08-05 06:33  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

This article briefly describes 13V/2A PSU For Handheld Rigs (LM723). This principle is easy to understand, but also very practical. Depth understanding of circuit elements, you can better grasp this principle. In this circuit, you can learn about and purchase these components: LM723.

This compact 13-V/2-A power supply for ham radio rigs and otherVHF/UHF portablePMRs is based on the STR2012/13 voltage regulator IC from Sanken Electric Co. Many power supplies for handheld amateur radio rigs are based on the LM317, LM350 or even the good old LM723. Unfortunately, these regulators are invariably associated with a fair number of external components, while we should also consider design factors like total power dissipation and input voltage range. TheSTRis a hybrid power IC containing a switch-mode power supply. It supplies a fixed output voltage and accepts relatively high input voltages.

Another advantage is its relatively high power dissipation rating. The 5-pinSTRis available for 5.1 V, 12 V, 13 V, 15 V and 24 V at an output current rating of 2 A. Here, the STR2012 and STR2013 are suggested for output voltages of 12 V or 13 V respectively. The normal operating voltage of most handhelds being between 12.6 V and 13.8 V, the STR1303 will be the preferred device in most cases. A high-speed crowbar circuit is added to the regulator output. Thyristor Th1 (a TIC106 or 2N4442) is triggered when the output voltage rises above the zener voltage of D2, that is, 15 volts (approximately). When this happens, the thyristor short-circuits the supply output, protecting the radio against over voltage and blowing fuse F1.

Figure:1 Circuit diagram

Figure 1 Circuit diagram

Diode D1 acts as a reverse polarity protection, also in combination with fuse F1. To allow for its dissipated heat, theSTRregulator should be mounted on a heatsink. Efficiency will be around 80%, with ripple rejection at a comfortable 45 dB. The raw input voltage to the regulator should be in the range 18 to 35 V. The coil, L1, may be selected from the range produced by New-port. The type 1430430 is suggested. If difficult to obtain, then an ordinary triac suppressor type may be used instead.

Note, however, that the inductance of these coils is usually just 100μH, so you have to count the number of turns and add another 0.7 times that number to arrive at about 300 μH. Finally, keep the wire between pin 3 of theSTRand ground as short as possible, and connect at least the negative terminals of C1 and C3 to this point to give a ‘star’ type ground connection.

 

 


Reprinted Url Of This Article:
http://www.eeweb.com/blog/extreme_circuits/13v2a-psu-for-handheld-rigs