Position: Index > Unclassified >

Discrete PWM Generator Circuit(NE555)

2017-08-11 14:12  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

This article describes the Discrete PWM Generator Circuit (NE555). The principle is very simple, very practical. The circuit components can help you understand better grasp this principle. For example, in this circuit, you can go to find and buy these components: NE555.

PWMwaveforms are commonly used to control the speed of DC motors. The mark/space ratio of the digital wave-form can be defined either by using an adjustable analogue voltage level (in the case of a NE555 basedPWMgenerator) or digitally using binary values. Digitally derivedPWMwaveforms are most often produced by the timer/counter modules in microcontrollers but if you do not want to include a microcontroller in your circuit it’s also quite simple to generate the signals using discrete logic components.

Circuit diagram:

Figure:1 Discrete PWM Generator Circuit Diagram

Figure 1 DiscretePWMGenerator Circuit Diagram

An extension of the circuit shown can produce twoPWMwave-forms from an 8-bit digital input word. Each signal has 15 values. The 8-bit word can be produced for example from an expansion board fitted in a PC or from an 8-bit port of a processor which does not have built-inPWMcapability or from a laptop’s printer port. The mark/space ratio is only programmable up to 15/16 rather than 16/16; a binary input of 0000 produces a continuous low on both outputs turning both motors off.

Similar circuits often employ a dedicated ‘enable’ input to turn the motors off but it is not necessary in this design. The diagram shows the circuitry required to produce just one waveform. For the full two channel circuit it is necessary to use an additional 74HC193. The clock signal produced by the HCF4060 generator can be used to drive both channels and the free flip flop in the 74HC74 package can be used for the second channel (the corresponding pin numbers are shown in brackets). Altogether the entire two channel circuit can be built using just four ICs.

 

 


Reprinted Url Of This Article:
http://www.eeweb.com/blog/extreme_circuits/discrete-pwm-generator-circuit