Position: Index > Unclassified >

Electronic Gate Keeper(L14F1)

2017-08-06 04:25  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

This article describes the Electronic Gate Keeper (L14F1). The principle is very simple, very practical. The circuit components can help you understand better grasp this principle. For example, in this circuit, you can go to find and buy these components: L14F1.

This circuit can do the job of a Gatekeeper and alerts you if someone passes through the gate. The alarm can be an AC bell or a Lamp. The alarm turns on for 1 minute and stops if the light barrier is restored again. Infrared rays are used as the light barrier to activate the alarm system based on a Phototransistor. The high gainNPNDarlington phototransistor L14F1 conducts when its face is illuminated with IR rays.

This brings its collector to ground potential. IC1 is used as a simple voltage comparator with a potential divider R2 and R3 connected to its inverting input. So that half supply voltage (6 volts) is available to its inverting input. Its non inverting input is connected to the collector of the phototransistor. Normally the output of IC1 will be low since T1 is conducting.

When the IR beam breaks, the collector of T1 becomes high and the voltage at the non inverting input of IC1 increases above the voltage at the inverting input and output becomes high. This triggers the relay driver T2 and relay turns on. Capacitor C1 gives a short delay at the non inverting input of IC1 to prevent false triggering. Capacitor C2 keeps the base of T2 high for a short time even if the IR rays restore.

Figure:1 Electronic Gate Keeper Schematics

Figure 1 Electronic Gate Keeper Schematics

Settings:

IR rays should be aligned exactly to the Phototransistor so as to keep the alarm off.Normal range of the circuit is 2 meters. This can be increased to 5 meters if a convergent lens is used in front of the IRLEDs.A buzzer can be used in the place of the relay, if AC alarm is not required.Instead of IRLEDs, a Laser pointer can be used to increase the range up to 25 meters.If Laser is used, take all precautions to prevent direct viewing.Enclose to the Phototransistor in a small case with an opening in front. This prevents the entry of ambient light.Fix the IRLEDs on one gate pillar and the Photo transistor on the opposite pillar with exact alignment 

 


Reprinted Url Of This Article:
http://www.eeweb.com/blog/extreme_circuits/electronic-gate-keeper