Position: Index > Unclassified >

Guitar pre amp based FET

2018-01-21 07:59  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

FET guitar pre amp 300x180 Guitar pre amp based FETThe circuit is called a guitar preamp, but actually not, because the gain is close to 1. However, due to its impedance, thereby allowing transmission with better sound quality using a long cable between the guitars and amps.

The Guitar pre amp circuit is based on a FET-type BS170, and require very little support components. The polarization of the gate (G, gate) of FET is provided by two resistors R1 and R2. Both resistors are also to set the input impedance of the assembly, which here is close to 500 ohms. The original scheme, the second resistor set at 92K each, and keep the input impedance of less than 50K, which may be too tight to plug the guitar.

BS170, As usual with this type FET or MOSFET power transistors smaller (TO92 plastic housing in particular), you should check the pin manufacturer in the document (datasheet), with consideration for the brand, because the manufacturers do not necessarily offer the same pinouts for the same component model. The BS170 is here using the Motorola brand and pinout is as follows.BS170 pin Guitar pre amp based FET


Reprinted Url Of This Article:
http://amplifiercircuit.net/guitar-pre-amp-based-fet.html