Position: Index > Unclassified >

How to build Jogging Timer Circuit Diagram

2018-11-15 11:33  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

3V Battery powered, Beeps after a fixed minutes delay

This circuit was developed since a number of visitors of this website requested a timer capable of emitting a beep after one, two, three minutes and so on, for jogging purposes. As shown in the circuit diagram, SW1 is a 1 pole 9 ways Rotary Switch. Setting the switch in position 1, the Piezo sounder emits three short beeps every minute. In position 2 the same thing happens after a 2 minutes delay, and so on, reaching a maximum interval of 9 minutes in position 9.

Circuit diagram:

Circuit diagram


R1_____________47K 1/4W ResistorR2_____________10M 1/4W ResistorR3______________1M 1/4W ResistorR4_____________12K 1/4W Resistor (see notes)C1,C3__________10μF 25V Electrolytic CapacitorsC2____________100nF 63V Polyester CapacitorD1___________1N4148 75V 150mA DiodeIC1____________4093 Quad 2 input Schmitt NAND Gate ICIC2____________4060 14 stage ripple counter and oscillator ICIC3____________4017 Decade counter with 10 decoded outputs ICQ1____________BC337 45V 800mA NPN TransistorSW1___________1 pole 9 ways Rotary Switch (see notes)SW2___________SPST Slider SwitchBZ1___________Piezo sounder (incorporating 3KHz oscillator)B1____________3V Battery (two 1.5V AA or AAA cells in series etc.)


Needing only one time set, rotary switch can be replaced by an hard-wired link.A DIP-Switch can be used in place of the rotary type. Please pay attention to use only one switch at a time, or the device could be damaged.Varying R4 from 10K to 15K you can obtain more or less than three short beeps after the preset time delay.To obtain a one-second beep only, after the preset time delay, disconnect pin 9 of IC1C from pin 9 of IC2 and connect it to pin 8 of IC1C.

Reprinted Url Of This Article: